First-floor services inspection

Opening the services model

Loading and verifying geometry…

Settings

Printable room sheets (PDF + images)

View controls

Drag to rotate · right-drag to pan · scroll to zoom

Touch: one finger rotates; two fingers pan / zoom.

See through the floor

Walls Focus room

Service layers

Inspection options

Conduit / pipe envelopes Cable-path reservations Driver & maintenance outlines Wall-crossing review markers Switchboard set-out distances

Approximate offset from the nearest modeled room corner along the wall, plus proposed mounting height above the modeled finished floor (AFF). Shown in 3D and Plan; hidden while walking. Focus a room for clearer labels; callouts that would overlap are omitted. Confirm the actual wall, openings and heights with your electrician on site.

What the symbols mean

Coloured routes: blue = normal power; orange = requested backup; green = data. Cyan / red = cold / hot water; purple / pink = waste / drain vents.

Neutral equipment: light fittings use grey geometry; outlined volumes mark devices, drivers and connection-space reservations. Supply colours belong to the routes, not the equipment.

Thin flat outlines: proposed maintenance access. These are see-through candidates, not solid ceiling plates or a confirmed hatch count.

Incoming-service outlines: provisional entry/enclosure locations, not surveyed supply entries. Tap any marker for its label and proposed service.

Requested backup does not mean separate mains and backup connections to the same device. Transfer arrangements and actual equipment remain unselected.

Pick a route or fitting

Tap the visible model to inspect a segment. Transparent walls do not block selection.

What is still provisional?